|
Colors
Applewood, Natural Spruce,
Butternut, Bronze Sycamore, Tan Pine, Honey Timber, Natural Cedar,
Woodtone Cedar, Redwood & Pecan.
Coverage Rate
The
first coat of High Sierra Log Stain will cover 150 – 300 square feet
per gallon, depending on the wood roughness. The second coat, applied
within 30 min. to 2 hours after the first coat, will cover 250-450
square feet per gallon.
Packaging
One-gallon and five-gallon plastic pails (with easy-off, easy-on lids).
Application Range
Surface temperature: 40°F minimum and rising, 95°F maximum and falling. For best performance, apply between 60°F and 90°F.
The coating should be applied and allowed to dry within this
temperature range. Application and curing below the minimum risks
freezing and slow drying which could lead to rain or snow damage.
Application above the recommended maximum risks drying too fast, with
poor penetration into the wood.
Compatibility
High
Sierra Log Stain is recommended for use with Log Jam Chinking, Log
Builder Caulking, Conceal Caulking, Symphony, and PeneTreat. It also
works well with most other caulking and chinking products, other
interior clear topcoats and other borate preservatives. However, contact Sashco for guidance when using with other manufacturers' products.
Shelf Life
18 months from date of manufacture (minimum), when stored at room temperature.
VOC
Less than 350 grams/liter
Dry Time
High
Sierra typically dries to the touch within 30 minutes to 2 hours,
depending on the condition of the wood surface and the weather. The
first coat should be allowed to dry until tack free before the second
coat is applied.
pH
8.0 – 9.5
Density
8 – 9 lbs. / gal
Odor
Very mild, slight ammonia odor
Solids
Approximately 22% by volume (varying slightly, color to color)
Viscosity
Brookfield, LVF, 30 – 150 centipoise, #3 spindle, 60 rpm
Freeze-thaw Stability
3 cycles minimum down to 0°F. For best stability, store at room temperature.
| 
Shopping Cart
